Promast Fixatie lijm Gun Foam PMF 625

Promast Fixatie lijm Gun Foam PMF 625

It is a low swelling and high adhesive polyurethane gun foam which is specially formulated for the bonding of polystyrene-based jacketing plates and jambs.

• It is low weight, unlike adhesive mortars, which does not put a static load on the building.
• Due to its low expansion, it applies very low pressure to the surfaces.
• It provides economical usage compared to alternative adhesives.
• It contains fire-retardant additives.
• Dries easily.
• It accelerates and facilitates the installation of insulation boards and contributes to heat insulation.
• It saves time as it accelerates the transition to the plaster stage after the insulation boards are bonded.

Application areas

• Bonding of EPS and XPS insulation boards to the exterior of buildings.
• Bonding polystyrene jambs to concrete, plaster, and wooden.
• Bonding polyurethane and rock wool panels.

Technical info

• Density: 21 kg/m³
• Tack-Free Time: 5-7 minutes
• Cutting Time: 25-35 minutes
• Shelf Life: 15 months
• Volume: 750 ml
• Shrinkage: 5% max

Application methods

1. Take off the protective lid from the adaptor.
2. Attach the foam gun to the adaptor by twisting or.
3. Attach the straw to the adaptor SLOWLY by twisting.
4. Turn the can upside down and shake vigorously.
5. Point the straw to the application area, hold the adaptor and twist the can until the foam comes out.
6. To adjust the foam output, turn the can left and right.
7. Place the protective lid onto the straw after the end of the application.

Technische datablad

8682315553031